SG-2000 MANUAL 110
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc. TEL: (206) 746-6310 FAX: (206) 746-6384
17.6 RS-232 Software Programming Functions:
Pressing "C" on the Main Menu presents a sub menu which will prompt you to
enter specific information as follows:
Program Sub Menu
[A] SCAN BANK [E] FREQUENCY STEP
[B] TIMER [F] TIME
[C] CHANNEL [G] DATE
[D] SCANNING RATE
A. Scan Banks:
Enter the desired Scan Bank to program.
B. Timer:
The following sub menu is presented to allow you to program the radio to
"wake up" at a preset time and operating in any specified mode.
Program Timer Menu
[A] SET ON & OFF TIME
[B] ON CHANNEL
[C] ON FREQUENCY
1. Press "A" to enter the timer's on and off time.
2. Press "B" to enter the desired timer's on channel.
3. Press "C" to program the on frequency .
Selecting option "C" on the Program Timer Menu presents the following
menu to set the radio's "wake up" frequency and mode:
Enter on Frequency [A] MODE A3H
RX FREQUENCY 0.0 [B] AUDIO FILTER VOC
TX FREQUENCY 0.0 [C] SIDE BAND USB
[D] ATTENUATOR
To Next Page
