SGC SG-2000 - 12.3 Push-Button Functions; Basic Functions; Frequency Functions

SG-2000 MANUAL 51
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc. TEL: (206) 746-6310 FAX: (206) 746-6384
12.3 Push-Button Functions
BASIC FUNCTIONS
Power ON/OFF Press POWER
NOTE: When you first turn on the SG-2000, it will automatically
switch to the last frequency used.
Monitor 2182 KHz Press EMER
Send Emergency ALARM Press EMER + SHIFT/FUNC
WARNING: Do not test this function unless you are operating the SG-2000 into
a properly shielded dummy load. Otherwise, authorities such as the U.S. Coast
Guard may begin a search effort.
Increase Volume Press Up Arrow to increase or Down Arrow to decrease
volume
Clarifier Press CLAR then Up Arrow or Down Arrow
NOTE: The Clarifier (receiver offset) has a range of +/-
600 Hz
Display Frequency Press FREQ
Display Channel Press CHAN
Change Channel Press CHAN until 4 dashes appear, enter channel
number, CHAN
EXAMPLE: To call KMI on channel 401 press: CHAN , 401
, CHAN
FREQUENCY FUNCTIONS
Enter a SIMPLEX Frequency Press PRGM , FREQ enter frequency, PRGM
NOTE: When a programming sequence begins
with PRGM, you must press PRGM at the end of