SG-2000 MANUAL 71
The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
©1995, SGC, Inc. TEL: (206) 746-6310 FAX: (206) 746-6384
changes of frequency you may use the UP/DOWN arrow. When these
arrows are used, the frequency will increment in the desired direction (UP
or DOWN) in steps of .1 (100 Hz), .5, 1, 3, and 5 KHz. The size of the step is
set by the Change Frequency Scan Step procedure described on page 69.
Frequency Change - Direct Entry
To change to a new operating frequency via the direct entry method, the
following steps are used:
1) Press “PRGM” to alert the memory that new information is coming.
2) Press “FREQ” to specify that frequency numbers will follow.
To Next Page
Loading...
