CLEANING THE FILTER
MAINTENANCE: ROBOT
Remove and empty the dust bin. Clean any hair or
debris o the Anti-Tangle Comb on the back of
the dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove dust and debris.
Rinse filter with water only, and let air-dry 24 hours
before reinstalling.
Reinsert the filter into the dust bin. Slide the dust
bin back into the robot.
CLEAN FILTER EVERY WEEK.
REPLACE FILTER EVERY TWO MONTHS. See sharkaccessories.com for replacement filters.
CLEANING THE BRUSHROLL
MAINTENANCE: ROBOT
Push up on the tabs on the brushroll access door,
then lift o the door.
Lift out the brushroll. Remove the cap on the end
of the brushroll. Clean o any hair or debris, then
replace cap.
Clean the brushroll periodically and whenever hair
appears.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down
until it clicks into place.
NOTE: When removing the brushroll cap, make sure to not let the bushing inside the cap fall out. When cleaning
brushroll, be sure to not cut anything other than hair, string, fibers, or other debris.
CLEAN BRUSHROLL EVERY WEEK.
REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN. See sharkaccessories.com for replacement
parts.
To Next Page
Loading...
Need help?
General
