CLEANING SENSORS AND CHARGING PADS
CLEANING SIDE BRUSHES
MAINTENANCE: ROBOT
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a damp cloth. Be sure to
let them air-dry completely before reinstalling them.
CLEAN SENSORS AND CHARGING PADS PERIODICALLY AS NEEDED. Gently dust o the sensors and pads located on the
bottom of the unit with a dry cloth or cleaning brush.
NOTE: Remove any side brushes that are bent or damaged. To remove a brush, lift it o its post. See "Installing the Side
Brushes" for instructions on how to attach and remove the brushes.
CLEANING THE FRONT CASTER WHEEL
REPLACING THE BATTERY
MAINTENANCE: ROBOT
Pull the caster wheel from its housing and remove
any debris buildup.
To remove the battery, turn the unit over and
unscrew the battery cover with a Phillips-head
screwdriver.
Unplug the old battery from its connector, then
plug in the new battery. Replace battery cover and
screw it back into place. See Battery Recycling
information on back of cover.
REMOVE AND CLEAN FRONT WHEEL EVERY WEEK. REPLACE FRONT WHEEL EVERY 12 MONTHS.
See sharkaccessories.com for replacement parts.
Clean the wheel housing, then reinsert the
caster wheel.
CLEAN SIDE BRUSHES AS NEEDED. CHECK WEEKLY.
RECOMMENDED REPLACEMENT SCHEDULE: Replace when visibly worn. See sharkaccessories.com for replacement parts.
To Next Page
Loading...
Need help?
General
