Sharp Aquos LC-40LE820M

15
Preparation
POWER button
POWER
a
button
NOTE
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
• Minor power is consumed when the unit is in standby
mode.
Turning the TV on/off
Press POWER
a
on the TV.
• The initial auto installation wizard appears.
1
Initial auto installation
When the TV powers on for the fi rst time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Confi rm the following before turning on the
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
Press
a
/
b
to select the desired language,
and then press ENTER.
2
Press
c
/
d
to select “HOME” or “STORE”,
and then press ENTER.
3
• HOME: “STANDARD” will be the default value for the “AV
mode” setting.
• STORE: “DYNAMIC (Fixed)” will be the default value for
the “AV mode” setting. If the “AV mode” is changed, the
TV will automatically switch back to “DYNAMIC (Fixed)”
when there is no further change to TV setting for 30
minutes. When selecting “STORE”, press
c
/
d
to select
“Yes”or “No” to confi rm.
The TV searches for, sorts and stores all
the receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress,
press RETURN.
5
NOTE
• HOME mode: Settings are optimised for normal home viewing and
energy effi ciency.
• STORE mode: Settings are designed for maximum impact in retail
store displays.
• To change the “STORE” mode to “HOME” mode, please refer to
page 57 to reset the unit.
• If you turn off the power on the TV after performing step 4, the
initial auto installation wizard does not appear. The auto installation
function allows you to execute the auto installation again from the
“Setup” menu. (See page 17.)
• The initial auto installation wizard will go off if you leave the TV
unattended for 30 minutes before searching for channels in step 5.
STOREHOME
Setting the country.
Press
a
/
b
to select your country or area, and
then press ENTER.
• This setting screen only appears during the initial
auto installation.
4
Turning on/off the power
• To turn on the power
Press POWER
a
on the TV. (After a few seconds, an
image appears with sound.)
NOTE
• Wait more than fi ve seconds until you press POWER
a
on
the TV after inserting the power plug.
• To turn off the power
Switch it off by pressing POWER
a
on the TV.
Standby mode
• To standby mode
If the TV is switched on, you can switch it to standby
by pressing POWER on the remote control.
• Switching on from standby
From standby, press POWER on the remote control.
40LE820M_en_vn_id.indd 1540LE820M_en_vn_id.indd 15 2010/06/11 9:49:492010/06/11 9:49:49