Sharp Aquos LC-40LE820M

42
Settings when using external devices
You can select which device is used for outputting
audio.
Press MENU and the MENU screen displays.
1
Press
c/d
to select “Setup”.
2
Press
a
/
b
to select “Headphone/Audio out
select”, and then press ENTER.
5
Headphone/Audio out select
Press
b
/
c
/
d
to select “Option”.
3
Press
a
/
b
to select “Terminal setting”, and
then press ENTER.
4
Press
a
/
b
to select the desired item, and
then press ENTER.
6
Selected items Description
Headphone Output audio through headphones.
Audio out Output audio through an A/V receiver
or surround audio controller.
CAUTION
• This terminal is also used for headphones. Reduce the
volume before using headphones. Overwhelming sound
may damage your hearing.
NOTE
• If you select “Audio out” when a cable is inserted in the
AUDIO IN terminal, the TV speakers are muted.
• When you select “Audio out”, you can adjust the TV sound
volume with the VOLk/l buttons on the TV or on the
remote control unit.
Press MENU and the MENU screen displays.
1
Press
b/c/d
to select “Option”.
3
Press
a
/
b
to select “Colour system”, and
then press ENTER.
4
Press
a
/
b
to select a compatible video signal
system of your equipment, and then press ENTER.
5
Auto
PAL
SECAM
NTSC3.58
NTSC4.43
PAL-60
You can change the colour system to one that is
compatible with the image on the screen.
NOTE
• Factory preset value is “Auto”.
• If “Auto” is selected, colour system for input signal is automatically
set. If an image does not display clearly, select another colour
system (e.g. PAL, NTSC 4.43).
• You can choose from “Auto”, “PAL”, “SECAM”, “NTSC3.58” and
“NTSC4.43” in the “TV” mode.
Colour system settings
SetupCH list
Menu
:Back:Enter
INPUT7(HDMI)
INPUT6(HDMI)
Input skip
Τerminal setting
[No]
[No]
INPUT3(RGB)
Skip Input selection of RGB
Yes No
This setting allows you to skip an input on the “Input
skip” menu.
Press MENU and the MENU screen displays.
1
Press c/d to select “Setup”.
2
Press
a
/
b
to select “Input skip”, and then
press ENTER.
5
Press
a
/
b
to select the Input (INPUT2 to
INPUT7) you wish to skip.
6
Press
c
/
d
to select “Yes”.
7
Press MENU to exit.
8
Skipping an input
Press
b/c/d
to select “Option”.
3
Press
a
/
b
to select “Terminal setting”, and
then press ENTER.
4
Press c/d to select “Setup”.
2
40LE820M_en_vn_id.indd 4240LE820M_en_vn_id.indd 42 2010/06/11 9:51:062010/06/11 9:51:06