Sharp AQUOS LC-40LE924RU

25
SCART connection
Example of connectable devices
E VCR
E DVDplayer/recorder


VCR Decoder
q SCART cable (supplied accessory)/Conversion
cable
r SCART cable
NOTE
• Incaseswhenthedecoderneedstoreceiveasignalfrom
theTV,makesuretoselecttheEXT1terminaltowhichthe
decoderisconnectedin“Manualadjust”inthe“Analogue
setting”menu(Page36).
• YoucannotconnecttheVCRwithdecoderusingafullywired
SCARTcablewhenselecting“Y/C”under“EXT1”inthe“Input
select”menu.
Y PB
(
CB)
PR
(
CR)
Component connection
Example of connectable devices
E VCR
E DVDplayer/recorder
Youwillenjoyaccuratecolourreproductionandhigh
qualityimagesthroughtheEXT3terminalwhen
connectingaDVDplayer/recorderorotherdevice.
LR
AUDIO
Y PB
(CB)
P
R
(CR)
(G) (B) (R)
COMPONENT


s Stereo conversion
cable*
t RGB component
cable (supplied
accessory)/
Conversion cable
* Thesuppliedconversioncable(AVcable)isonlyusedfor
theEXT2terminal,notfortheAudioIN/OUTterminal.Usea
stereoconversioncable(commerciallyavailable)instead.
E After connecting
Youmustselecttheappropriateinputsourceand
inputsignalsettingsforcomponentconnectionto
enjoyhighqualityimagethroughtheEXT3terminal.
Selecting the component signal
1 Press b to select “EXT 3” from the
“INPUT” menu, and then press ;.
2 Go to “Menu” > “Setup” > “Option” >
“Terminal setting” > “Input select” >
select “COMPONENT”.
Setting audio output
Go to “Menu” > “Setup” > “Option” >
“Terminal setting” > “Audio select” >
select “Video+Audio”.
Connecting external devices