Sharp CD-DVD500H - Page 60

ENGLISH
60
CD-DVD500H
Using the radio data system (RDS) (continued)
RDS radio
- Using the radio data system (RDS) -
To automatically play the traffic information
(EON-TI)
When the traffic information is broadcast, the radio will switch to it automatically.
1 Tune in to an RDS station (when a station name is displayed).
2 Press the EON button when “EON” appears.
“SELECT” and “PTY TI” will appear alternately for about 6 seconds.
If the EON button is pressed when “EON” is not displayed, “NO EON” will
appear for 5 seconds to indicate that the unit cannot enter the EON stand-by
mode.
3 Whilst they are displayed, select the TI (Traffic Information) by
pressing the PRESET
XX
XX
X or
WW
WW
W PRESET button.
4 Within 4 seconds, press the PTY. TI button.
“TI” and “WAITING” will appear for 2 seconds each.
“TI” will appear, and the unit will enter the EON-TI stand-by mode.
5 When a TA specified starts on an ON (other network) station, the
unit will automatically switch to that station, and “TI” will flash.
6 When the traffic information is over, the unit will automatically
return to the original station.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button. (“TI” “WAITING”)
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press it
again. (“TI” will go out.)