02/5/27 CD-XP120W(A)2.fm
E-13
ENGLISH
CD-XP120W
Basic Operation
- Setting the clock -
Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 8 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC
power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the time display is
flashing, step 3 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK button and within 8 seconds, press the
MEMORY/SET button.
3 Within 30 seconds, press the PRESET ( or ) button to
select 24-hour or 12-hour display and then press the MEM-
ORY/SET button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset. [Refer to "Clearing all the memory (reset)" on
page 27 for details.]
4 Within 30 seconds, press the PRESET ( or ) button to
adjust the hour and then press the MEMORY/SET button.
"
Press the PRESET ( or ) button once to advance the time
by 1 hour. Hold it down to advance continuously.
"
When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
5 Within 30 seconds, press the PRESET ( or ) button to ad-
just the minutes and then press the MEMORY/SET button.
"
Press the PRESET ( or ) button once to advance the time
by 1 minute. Hold it down to advance continuously.
"
The hour will not advance even if minutes advance from "59"
to "00".
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 27 for details.]
2 Perform "Setting the clock" from the beginning.
To Next Page
Loading...
