Sharp CD-XP120W

02/5/27 CD-XP120W(A)3.fm
E-21
ENGLISH
CD-XP120W
Karaoke
- Playing karaoke -
Playing karaoke
Notes:
!
When you sing too loud through the microphone, your voice may
be distorted depending on the devices connected. If this hap-
pens, lower the microphone volume.
!
If an extremely sensitive microphone is used, howling may be
generated.
!
Unidirectional microphone is more appropriate for vocal use.
If squealing occurs:
!
Reduce the microphone volume.
!
Change the direction of the microphone.
!
Reduce the volume of the main unit.
!
Move the microphone away from the speakers.
Caution:
!
When not using the microphone, remove it from the MIC socket.
!
When connecting or disconnecting the microphone, turn the MIC
LEVEL control fully anti-clockwise.
"
Recording of mixed sound to a cassette
tape
You can record mixed sound from the microphone and CD, TUNER
or TAPE 2.
Note:
To record the microphone signals only, load a cassette into the
TAPE 1 cassette compartment and press the TAPE button. Then,
press the button of TAPE 1.
1
Turn the MIC LEVEL control fully anti-clockwise to pro-
tect the speakers from shock noise and to avoid dis-
turbing noises.
2
Connect the microphone to the MIC socket.
!
Use a microphone with a 6.3 mm (1/4") plug, an impedance
of 600 ohms.
!
Use a standard plug adaptor when using a microphone with
a 3.5 mm (1/8") diameter plug.
3
Press the ON/STAND-BY button to turn the power on.
4
Press the CD, TUNER or TAPE button to select the au-
dio source and play it.
5
Adjust the volume of the audio source using the VOL-
UME buttons.
6
Rotate the MIC LEVEL control clockwise to increase the
microphone volume and anti-clockwise to decrease it.
1 Perform steps 1 - 3 above.
2 Load a cassette into the TAPE 1 cassette compartment.
3 Perform steps 4 - 6 above.
4 Press the button of TAPE 1.
5 Press the button of TAPE 1, which also engages the button.
6 Press the button of TAPE 1 again to begin recording.