Sharp CD-XP120W

02/5/27 CD-XP120W(A)3.fm
E-23
ENGLISH
CD-XP120W
Tape Recording
- Recording to a cassette tape -
Recording to a cassette tape (continued)
"
Recording from the radio
To stop recording:
Press the button of TAPE 1.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
"
Dubbing from tape to tape
You can record from TAPE 2 to TAPE 1.
To stop dubbing:
Press the button of TAPE 1.
"
Erasing recorded tapes
Notes:
!
Do not connect anything to the MIC socket.
!
Make sure that the TAPE 2 is not in use.
1
Tune in to the desired station. (See page 18.)
2
Load a cassette into the TAPE 1 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button of TAPE 1.
4
Press the button of TAPE 1,
which also engages the but-
ton.
5
Press the button of TAPE 1 again to begin recording.
Erase-prevention tab of cassette tapes:
!
When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
!
To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
Side A
Tab for
side B
Tab for
side A
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 2 cassette
compartment. Insert a blank tape into the TAPE 1 cas-
sette compartment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE button.
4
Press the button of TAPE 1.
5
Press the button of TAPE 1, which also engages the
button.
6
Press the button of TAPE 2.
The button of TAPE 1 will be released automatically and dub-
bing from TAPE 2 to TAPE 1 will begin.
1 Load the tape to be erased into the TAPE 1 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE button.
3 Press the button of TAPE 1, which also engages the button
to begin erasing.