Sharp CD-XP120W - Tape Playback: Single Tape Operation; Playing TAPE 1 or TAPE 2

02/5/27 CD-XP120W(A)2.fm
E-20
ENGLISH
CD-XP120W
Tape Playback
- Listening to a cassette tape -
!
TAPE 1 or TAPE 2 playback
To stop playback:
Press the button.
Fast forward/rewind:
To advance the tape, press the button, then press the but-
ton. To rewind, press the button, then press the button.
To interrupt playback (TAPE 1 only):
Press the button during playback.
Press the button again to resume playback.
"
Do not press the button whilst the fast forward or rewind opera-
tions are in progress. The or button will not be released
when the tape end is reached. Once this occurs, press the
button.
Caution:
"
Before changing from one tape operation to another, press the
button.
"
If TAPE 1 and TAPE 2 are played simultaneously, only the sound
from TAPE 2 will be audible.
!
Continuous playback (TAPE 2 to TAPE 1)
Note:
When in the continuous play mode, pressing the button of
TAPE 2 will start TAPE 1 automatically.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the button to open the cassette door.
3
Load a cassette into the TAPE 1
or TAPE 2 cassette compart-
ment with the side to be played
facing toward you.
4
Press the TAPE button.
5
Press the button of TAPE 1 or TAPE 2 to start play-
back.
TAPE 1
TAPE 2
1
Press the ON/STAND-BY button to turn the power on.
2
Press the button to open the cassette door.
3
Load cassettes into the TAPE 1 and TAPE 2 cassette
compartments with the side to be played facing toward
you.
4
Press the TAPE button.
5
Press the button of TAPE 2.
6
Press the button of TAPE 1.
7
Press the button of TAPE 1.
When TAPE 2 stops at the end of the tape, the button of
TAPE 2 and the button of TAPE 1 will be automatically re-
leased, and TAPE 1 will start playing.