Sharp ER-A220

18
Programming the department text
You can program a maximum of 16 characters of text for each department. Program the text by entering the
character codes.
*To program departments 16 through 30, press the department shift key at this point.
Programming the PLU text (item label)
You can program a maximum of 16 characters of text (item label) for each PLU or subdepartment. Program the
text by entering the character codes.
Programming the function text
You can program a maximum of 12 characters of text for each function key and other functions using the table
on the following pages. Program the text by entering the character codes.
* Function no.: See “List of function texts” shown on the following page.
Text
programmed for
PLU code 1
Ñ
2
.
1
Ö
077
º
069
º
076
º
079
º
078
º
ÑÉ
PrintKey operation example
Text
programmed for
dept. 1
Ñ
1
.
070
º
082
º
085
º
073
º
084
º
¯É
PrintKey operation example
Ñ .1
Character code (3 digits) Dept. key
É
To keep the current setting
To program another department
Up to 16 characters
º
Ó
*
Ñ
.2 Ö
PLU code
To program the next PLU
Up to 16 characters
Character code
(3 digits)
ÉÑ
To keep the current setting
º
To program another PLU
Ñ .3 ≈
*Function no.
(max. 2 digits)
Up to 12 characters
Character code
(3 digits)
ÉÑ
To keep the current setting
º
To program another function text
Downloaded from: http://www.usersmanualguide.com/