Sharp ER-A280N - 9 Non-Accessed EAN Deletion; Non-Accessed EAN Report

Non-accessed EAN Deletion
You can delete EANs that had not been accessed for a certain period. You can program a period
in the PGM2 mode.
Follow the procedure shown below.
Non-accessed EAN deletion
1. Select the X1/Z1 mode from the mode selection screen.
2. Select “4 EAN DELETE”.
3. Select “1 READING” to take a report, or “2 DELETE” to delete non-accessed EANs.
4. When you select “2 DELETE”, select you want to delete all the non-accessed EANs (1 ALL DELETE) or
delete the non-accessed EANs individually (2 IND.DELETE).
It is recommended to take a report first before executing deleting operation.
NOTE
9
94
■ Non-accessed EAN report
Item label
EAN code
*1
*2
*1 When you select “DELETE”, “Z1” is printed instead of “X1”.
*2 When there is any sales data of the EAN for PLU/EAN report, the data is printed here.
When you delete the EAN in Z1 mode under this situation, the EAN data for PLU/EAN report is also
deleted.
ER-A280F_N(SEEG)(E)-5 09.6.18 6:52 AM Page 94