Sharp ER-A320

2. Flash report
REPORT NAME KEY ENTRY
MODE
DATA FOR READING REMARK
OP X/Z X1/Z1 X2/Z2
XZX1
Z1
X2
Z2
NET3 CA/AT
DEPT
DPTn
DEPT. CODE
DPT#
DEPT/GROUP
MDSE SBTL
GROUP CODE
HOURLY
#/TM/SBTL
TIME
CID
@/FOR
To read respective reports, it is necessary to follow the procedure
below.
To read respective reports, it is necessary to foIIow the pro-
cedupe below.
To read respective reports, it is necessary to follow the procedure
below.
3. Overflow mark
If the amount in any totalizer other than GT to be printed on X or Z
reports exceeds a programmed limit, the indication mark (overflow
mark) is printed for the totalizer concerned.
The overflow mark may be printed even it a totalizer does not reach
the maximum amount. This occurs. for example, when the amount in
the totalizer gets smaller than the maximum amount due to the entry of
a negative amount after the overflowing of the totalizer. This means
that when the totalizer overflows once. the overllow mark (for example,
"
★★★ ") is printed.
TIME
TIME : 24 hour system (2 digits)
#/TM/SBTL
DEPT#
Dept. code
XX
MDSE SBTLGroup No.