Optional Settings
108
Setting 05: TRANSACTION REPORT PRINT SELECTION
This sets the condition for printing out a Transaction Report. Enter a number
from to as follows:
♦ Initial setting: 5
Setting 06: RECALL TIMES
This sets the maximum number of times your fax will automatically redial if the
line is busy. Enter any number from to .
♦ Initial setting: 02
Setting 07: RECALL INTERVAL
This sets the amount of time your fax will wait between automatic redials
when the line is busy. Enter for 1 minute, for 2 minutes, etc.,
up to a maximum of 15 minutes.
♦ Initial setting: 05
Setting 08: SECURITY SELECTION
Press (ON) to turn polling security on, or (OFF) to turn it off.
♦ Initial setting: 1
(ERROR/TIMER
MEMORY):
A report will be printed after an error, timer
operation, or memory operation
(SEND ONLY) A report will be printed only after a
transmission
(ALWAYS PRINTS) A report will be printed after each
transmission, reception, or error
(NEVER PRINTS) A report will never be printed.
(ERROR ONLY) A report will be printed only after an error
occurs
1
5
0 0
1
4
0
1
0
2
1 2
.
5
1
2
4
3
To Next Page
Loading...
