Timer Operations
77
5. Special
Functions
Timer Operations
The Timer function allows you to store a job to be performed automatically at
a specified time. Up to 59 timer jobs can be stored at any one time, and the
time of each can be specified up to a week in advance.
You can use this function to take advantage of lower off-peak rates without
having to be there when the operation is performed.
Note: cannot be used for a timer transmission.
Initial procedure
To store a timer job, first perform the following procedure. After you have
completed this procedure, go to the procedure for the specific job you want to
store (see the following pages).
DOCUMENT
M/?
1
Press . (Flip up the Rapid Key
overlay if it is down.)
2
Press to select SET.
3
Enter a number as follows to select the desired operation (or scroll to
the desired operation with or and press ).
Transmission (SEND MODE)
Confidential transmission
Polling
Serial Polling
Broadcasting
4
Enter a two-digit number for the hour (“01” to “12”) and a two-digit
number for the minute (“00” to “59”).
TIMER
X/>
1
START/
ENTER
1
2
3
4
5
Display:
TIMER MODE
1=SET, 2=CLEAR
To Next Page
Loading...
