L T F P
4
N
Close the cover, and at the same time
pull the paper out through the outlet so
that there is no slack in the compartment,
● A short length of the fax paper will
feed out and be cut off. (If this doesn’t
happen, repeat the Ioadlng procedure.)
The fax has a built-in anti-curl mechanism that will help to reduce paper curl-
ing problems, Theanti-curl mechanism will be more effect!ve at the begin-
ning of thepaper roll and less effective towards the end.
To assure a long life for your fax and obtain the best reproduction quality, we
recommendthat you use the following Sharpfax (thermal) paper which ISavailable
from your dealer:
FO-40PR THERMAL PAPER (50
m r
+ The use of any other paper may result in poor copy quality and excessive
build-up of residue on the head, This is due to the different thermal reactive
characteristics of each manufacturer’s paper.
+ Other manufacturerspaper may not have paper out sensor Ilne at end of roll
which could cause messagesto be lost and may cause the cutter to Jam.(see
Chapter 11 “Clearlng paperjams”)
When the paper runs out, OUT OF PAPERwill appear in the displa}. Reception and
copying wili no longer be possible. To replace the paper, first take out the old roll,
then load the new roll as described above.
Do not unpackthe paper untilyou are readyto use it. It may become dlscolouredif:
+ It is stored at high humidity or high temperature.
+ It ts exposed to direct sunllght.
+ It comes in contactwith glue, thinner, or a freshly copied blueprlnt
+ A rubber eraser or adhesivetape is used on It. or it ISscratched
1-6
INSTALLATION
To Next Page
Loading...
