Sharp HT-CN410DVH

E-41
HTCN410DVH 8_E2.fm03/10/29
ENGLISH
F
S
V
I
N
P
E
E
HT-CN410DVH
Radio Operation
- Listening to the radio -
Listening to the radio
 Manual or Auto tuning
When an FM stereo broadcast is received...
 "STEREO" will appear.
 If the FM reception is weak, press the ST/MO button to extinguish the "STEREO"
indicator. The reception changes to monaural, and the sound becomes clearer.
Note:
The sound is produced in 2-channel stereo whilst receiving radio broadcasts.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the FUNCTION (FM/AM) button repeatedly to select the
desired frequency band.
3 Press the or (TUNING 4 or 3) button for a few seconds to
tune in to the desired station.
Manual tuning:
Press the or (TUNING 4 or 3) button as many times as required to tune
in the desired station.
Auto tuning:
When the or (TUNING 4 or 3) button is pressed for 0.5 seconds or
more, scanning will start automatically and the tuner will stop at the first receiv-
able broadcast station.
 When radio interference occurs, auto scan tuning may stop automatically at
that point.
 Auto scan tuning will skip weak signal stations.
 To stop the auto tuning, press the or (TUNING 4 or 3) button again.
FM stereo receiving indicator
A-B REPEAT 1SLEEPPROGCHPPRESETTRKTITLE
KHz
CD MP3V
DIGITAL
Pro Logic
RSLS
C
RL
S
MHz
STEREO
A-B REPEAT 1SLEEPPROGCHPPRESETTRKTITLE
MHz
CD MP3STEREO V
DIGITAL
Pro Logic
RSLS
C
RL
S
KHz
FM AM
A-B REPEAT 1SLEEPPROGCHPPRESETTRKTITLE
KHz
CD MP3V
DIGITAL
Pro Logic
RSLS
C
RL
S
MHz
STEREO