Sharp HT-CN410DVH

E-42
HTCN410DVH 8_E2.fm03/10/29
ENGLISH
HT-CN410DVH
Radio Operation
- Listening to the radio -
Listening to the radio (continued)
 Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a
button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
 To recall a memorised station
1 Perform steps 1 - 3 in "Manual or Auto tuning" on page 41.
2 Press the MEMORY button to enter the preset tuning saving mode.
3 Press the direct number buttons to
select the preset channel number.
If the preset channel number is 2 digits, press "+10" and enter the number.
Example:
To select preset channel 1: Press "1".
To select preset channel 12: Press "+10" and "2".
To select preset channel 22: Press "+10", "+10" and "2".
Store the stations in memory, in order, starting with preset channel 1.
4 Press the MEMORY button to save
the station to memory.
5 Repeat steps 1 - 4 to set other stations, or to change a preset
station.
When a new station is stored in memory, the station previously memorised will be
erased.
A-B REPEAT1SLEEPCHPPRESETTRKTITLE
KHz
CD MP3V
DIGITAL
Pro Logic
STEREO
MHz
PROG
PROG
KHz
CD MP3V
DIGITAL
Pro Logic
STEREO
MHz
PROG
PROG A-B REPEAT 1SLEEPCHPPRESETTRKTITLE
KHz
CD MP3V
DIGITAL
Pro Logic
STEREO
MHz
1 Press the FUNCTION button to select FM or AM mode.
2 Press the PRESET ( or ) button to select the desired station.
Preset channel Frequency and frequency band
You can use the direct number buttons.
KHz
CD MP3V
DIGITAL
Pro Logic
RS
STEREO
PRESET
MHz
KHz
CD MP3V
DIGITAL
Pro Logic
RS
STEREO
MHz
PRESET