E-26
Sudden temperature changes,
storage or operation in an extremely
humid environment may cause
condensation inside the cabinet or
on the transmitter on the remote
control. Condensation can cause
the sound bar to malfunction. If this
happens, leave the power on until
normal playback is possible (about
1 hour). Wipe off any condensation
on the transmitter with a soft cloth
before operating the sound bar.
When this product is subject to strong
external interference (mechanical
shock, excessive static electricity,
abnormal supply voltage due to
lightning, etc.) or if it is operated
incorrectly, it may malfunction.
If such a problem occurs, do the
following:
1. Set the sound bar to the standby
mode and turn the power on
again.
2. If the sound bar is not restored
in the previous operation, unplug
and plug in the sound bar again,
and then turn the power on.
Make sure to disconnect all output
and input cables attached to the
sound bar before performing the
factory reset.
1. During standby mode, on the
sound bar, press the button.
2. Then, press and hold the
button until white, green and
orange LED indicator light up
simultaneously.
Caution:
This operation will erase all data
stored in memory.
Troubleshooting chart (continued)
Condensation
If problem occurs during
operation
Factory reset, clearing all
memory
To Next Page
Loading...
Need help?
General
