Sharp HT-SB602

E-18
EN
Maintenance
 Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth.
Caution:
z Do not use chemicals for cleaning (petrol, paint thin-
ner, etc.). It may damage the cabinet nish.
z Do not apply oil to the inside of each component. It
may cause malfunctions.
Error indicators and warnings
When you fail to perform operations properly, the follow-
ing messages are displayed on the sound bar.
Display Meaning
(Display blinks)
z When there is no input signal.
Play back the connected
equipment.
z Nonstandard signal. Cannot
be recognized.
z Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
z Poor connection of the digital
audio input terminal.
z Turn off the sound bar
and check if the cable is
connected properly.
Error indicator
(blinks red)
z When the protection circuit is
activated.
(*): Should the same message appear even if the
speaker is unplugged and plugged in, or is set to
the standby mode and on again, contact your local
dealer where you purchased the sound bar.
Specications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specication
changes for product improvement without prior notice.
The performance specication gures indicated are
nominal values of production unit. There maybe some
deviations from these values in individual unit.
 Sound Bar
Power source AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 38 W
Power standby: 0.4 W (*1)
Power standby: < 6 W (*2)
Dimension Width: 1386 mm
Height: 74 mm
Depth: 68 mm
Weight 3.7 kg
Output power RMS: Total 160 watts
RMS: 160 W
(80 W + 80 W) (10% T.H.D.)
RMS: 120 W
(60 W + 60 W) (1% T.H.D.)
Output
terminal
HDMI™ output: (audio/video support
up to 1080p) x 1
Input terminal 500 mV / 47 kohms
Optical digital input (OPTICAL):
Square type x 1
HDMI input: (audio/video support up
to 1080p) x 2
Type 2 Way speaker system
5.7 cm woofer
2.5 cm Soft Dome
Bluetooth
Frequency
band
2.400GHz - 2.480GHz
Compatible
Bluetooth
Prole
A2DP (Advanced Audio Distribution
Prole), AVRCP (Audio/Video
Remote Control Prole)
Bluetooth 2.1 +EDR
Maximum
input power
160 W
Rated input
power
80 W
Impedance 4 ohms
(
*1): This power consumption value is obtained when the
sound bar is in low power consumption mode.
( *2): This power consumption value is obtained in the STANDBY
mode.
 Subwoofer
Power source AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 33 W
Power standby: 0.4 W (*1)
Power standby: 0.4 W (*2)
Output power RMS: 150 W (10% T.H.D.)
RMS: 120 W (1% T.H.D.)
Type Subwoofer system
16 cm woofer
Maximum
input power
300 W
Rated input
power
150 W
Impedance 3 ohms
Dimensions Width: 144 mm
Height: 432 mm
Depth: 306 mm
Weight 6.1 kg