Sharp IQ-8920 - Getting the Unit up and Running; Installing the Batteries; Lnitializing

Getting the Unit Up and Running
Installing
1. Set the battery replacement switch on the back of the unit
the
to “REPLACE BATTERIES” (exposing the red dot).
batteries
2. Slide off
the operation battery cover.
3. Insert the two batteries atop the ribbon tab, positioning
them according to plus (+) and minus (-) polarity, as
shown below.
4. Replace the operation battery cover.
5. Set the battery replacement switch to “NORMAL
OPERATION”.
lnitializing
The unit must be initialized the first time it is used.
1. Press and hold the (ON) key.
48