Film mode: · Automatically detects a film-
based source (originally encoded at 24 or
25 frames per second, depending on the
vertical frequency), analyses it and then
recreates each still film frame for high-
definition picture quality.
[Effect] — MJC effect selection. Set the
effect from Low / Middle / High, or set to Off
to disable this function.
Press 4. ≤≥ to select / adjust the item to the
desired level.
Follow the on-screen instructions to exit.5.
Use smart picture
Apart from manually adjusting picture settings, you
can use Smart picture to set your TV to a predefined
picture setting.
Press 1. MENU on the remote control and select
Picture.
Press 2. OK or ≥ to enter Picture and select
Smart Picture.
Press 3. ≤≥ to select one of the following
settings:
Personal•
Standard•
Vivid•
Movie•
Eco•
Follow the on-screen instructions to exit.4.
Sound
Adjust sound settings
This section describes how to adjust sound settings.
Press 1. MENU on the remote control and select
Sound.
Press 2. OK or ≥ to enter the list.
Press 3. o> to select one of the following
settings:
Brightness: • Changes the level of light in the
picture.
Contrast: • Changes the level of bright parts in
the picture keeping the dark parts unchanged.
Colour: • Changes the level of saturation.
Tint: • Changes the colours to reddish or bluish.
Sharpness: • Changes the level of sharpness of
fine details.
Colour temperature:• Sets the colour
temperature to Cool (bluer), Normal
(balanced), Warm (redder).
Advanced Control: • Press OK or ≥ to enter
and press <> to select one of the following
item:
Noise Reduction:* Filters and reduces the
noise in the picture. Selects the level to Low
/ Medium / High / Auto. Or select Off to
disable this function.
Flesh Tone: * Selects On to set the flesh
colour to be more natural.
Back Light: * Adjusts the background brighter
or darker. (Only if the DCR is off.)
DCR (Dynamic contrast ratio):* Enhances
the contrast in the picture as the image on
the screen changes. Press ≤≥ to switch
active control On or Off.
Advanced (Only for 32”/37”/42”):*
[Mode] — MJC (
Motion Judder Compensation
)
mode selection. Set 100Hz to let TV display
on 100Hz frame rate. Set Film Mode to
decrease picture judder in film play.
100Hz: · “100 Hz” technology provides
superior solutions for digital display picture
quality removing motion blur.
NOTE
This effect is greater on fast moving images. −
100 Hz will have no effect in the following −
cases.
1)
The type of signal received is a PC signal.
2) An OSD is being displayed.
3) Teletext is activated.
If images appear blurred, set the − 100 Hz
to Off.
TV menu