TV menu
Step 3: Automatic channel scan
Your TV searches and stores all available digital and
analogue TV channels as well as all available digital
radio channels.
Press 1. MENU on the remote control and select
TV ≥ Channels.
NOTE
You are prompted to enter current password to enter •
Channels if Channel Block /Parental Guidance /
Input Block in the Parental menu is not the default
setting.
Select 2. Channel Scan and press OK or ≥
and select ATV only or ATV and DTV to start
channel installation. The installation may take a
few minutes.
When complete, follow the on-screen 3.
instructions to exit.
Update Scan E
Update Scan has similar function with Channel Scan.
The difference is you could update channel list without
erasing the original information.
NOTE
This function is for Antenna mode only.•
Press 1. MENU on the remote control and select
TV ≥ Channels.
NOTE
You are prompted to enter current password to enter •
Channels if Channel Block /Parental Guidance /
Input Block in the Parental menu is not the default
setting.
Press 2. <> to select Update Scan and press
OK or ≥ to start channel update.
When complete, follow the on-screen 3.
instructions to exit.
Single RF Scan E
If using digital broadcasts, you can check the quality
and signal strength of digital channels. This allows you
to reposition and test your antenna or satellite dish.
Press 1. MENU on the remote control and select
TV ≥ Channels.
NOTE
You are prompted to enter current password to enter •
Channels if Channel Block /Parental Guidance /
Input Block in the Parental menu is not the default
setting.
Press 2. <> to select Single RF Scan and press
OK or ≥ to enter.
Antenna mode
<3. Antenna Mode>
Highlight the RF Channel box, and press ≤≥
to select a channel number you prefer to scan.
<Cable Mode>
Configure the Frequency, Modulation, and
Symbol Rate box to scan.
Press 4. OK to start scanning.
When the scan is completed, the result of 5.
signal strength and signal quality appear on the
screen.
Follow the on-screen instructions to exit.6.
NOTE
If the signal quality and strength is poor, reposition the •
antenna or satellite dish and retest.
If you have further problems with the reception of your •
digital broadcast, contact a specialised installer.
Analogue Manual Scan E
This section describes how to search and store
analogue TV channels manually.
Press 1. MENU on the remote control and select
TV ≥ Channels.
NOTE
You are prompted to enter current password to enter •
Channels if Channel Block /Parental Guidance /
Input Block in the Parental menu is not the default
setting.
To Next Page
Loading...
Need help?
General