EasyManuals Logo

Sharp LC-32LE700E User Manual

Sharp LC-32LE700E
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
LC-32/40/46LE700E/RU/S,LU700E/S,LX700E/RU,LC-52LE700E/RU/S
5 – 9
6. Setting items (* Item names and selective items are expressed in English.)
1) Power ON fixed [POWER ON FIXED]
If the power button is pressed in the ordinary mode in setting to “FIXED_ALL”, the caution is displayed for 5 seconds.
* The OSD display is an example.
If another ODS is previously displayed, the status is reset (MENU or similar).
2) Instantaneous current shutdown setting in turning off the power [SHUT DOWN MODE]
3) Volume maximum level [MAXIMUM VOLUME]
Option “VARIABLE”,”FIXED_ALL”, “FIXED_BODYKEY” or “RCRESPOND” (loop enabled)
Default “VARIABLE”
Function • VARIABLE
FIXED_ALL
FIXED_BODYKEY
RC RESPOND
: “POWER/RECEPTION” key on TV unit or remote control is enabled
: “POWER/RECEPTION” key on TV unit or remote control is disabled.
: only the “MAIN POWER” key on TV unit is disabled
(the remote control is enabled).
: the main unit’s POWER switch toggles between ON and Standby
(the same operation by the remote control).
Key disabled when set
other than default
OFF TIMER (SLEEP)
In selecting to “FIXED_ALL”, function related standby factors (see below) doesn't work. and not selecting
OFF TIMER (Sleep)
No operation OFF
No signal OFF (including the power management)
Option “NORMAL” or “QUICK”
Default NORMAL
Function This function decides whether scanning digital tuner is enabled or disabled when the power is standby.
NORMAL
QUICK
: Scanning digital tuner is enabled when the power is standby.
: Scanning digital tuner is disable
It is possible to put into the standby state instantaneously due to power off input, when the power is standby.
Immediately, state is a complete standby.
Remarks In selecting “QUICK”, the function does not work for the following items
(selection impossible.)
ON TIMER, QUICK START, DIGITAL FIXED, etc.
Option 0~60(loopdisabled)
Default 60
Function The volume cannot be increased more than the adjusted value (the main unit’s speaker only).
Remarks In setting to 59 or less, only the figure is displayed in the normal mode; the volume bar is not displayed.
The volume of the headphones or monitor output is limited.
The setting is impossible when VOLUME FIXED is set other than VARIABLE.
When power button on the main unit is pressed When power buttonon R/C is pressed
No Power off by power button.
No Power off by remote control.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp LC-32LE700E and is the answer not in the manual?

Sharp LC-32LE700E Specifications

General IconGeneral
Display diagonal32 \
Native aspect ratio16:9
Native refresh rate100 Hz
RMS rated power20 W
Number of speakers2
PC in (D-Sub)Yes
HDMI ports quantity4
USB 2.0 ports quantity1
Weight and Dimensions IconWeight and Dimensions
Depth (without stand)92 mm
Width (without stand)767 mm
Height (without stand)502 mm
Weight (without stand)13500 g

Related product manuals