Is it possible setup Inbound Routing
using Email destination addresses?
MX-C250/300 series only supports Network Folder
destinations when configuring Inbound Routing.
Can the Ethernet speed of the
MXC250/300 series be fixed?
Upgrade the MFP Firmware to Special ROM version
02.05.E1.f0
After reboot, Log in using Admin Mode via the Web page.
Under Network Setup > General Configuration, set Auto-
Negotiation, Speed and Duplex Modes accordingly
C1-10 trouble after recovering from
Power Save mode
Upgrade the MFP Firmware to v02.00.E1 (or higher).
This may be caused by static electricity discharged due to
poor earthing of the fusing separation plate.
Add fusing separation earth spring [MSPRT0655QSZZ ],
screw [XEBS730P12000] & washer [XWHS730-05080] to
the rear side of the fusing unit.
Check to see if the wire harness for the primary transfer
positioning sensors is routed correctly and is not
clamped/pinched between the high voltage TC holder and
the chassis.
NG Example
SIM24-6 - SIM24-15 are missing?
To avoid counters that can be cleared accidentally
(affecting End User Counter data/information), these
Simulations are now hidden as default.
Double sheet feeding from the SPF
The SPF separation pad has been upgraded to the same
type used on MX-C301W. Replace with PSHEZ0837QSZZ
To Next Page
Loading...
Need help?
General
