Note: Excludes Part Change/Correction Information.
Cautions to prevent F3-22 trouble caused by broken 2CS sensor
harness.
Serial Number Identification
Enhancement of operability in opening/closing the Multi Manual Paper
Feeding Unit
Printer installation under Mac OSX 10.10
Enhancement to improve paper jam at the transport paper guide.
Measures to prevent noise when feeding paper from RSPF unit.
Measures against H3 trouble caused by the static electricity discharge
within the fusing unit.
Measures against toner smudge on the paper
Measures to prevent noise when feeding paper from bypass tray
Measures to prevent noise from the paper feed roller.
New part registration - Delivery auxiliary guide.
Open SSL vulnerability - Firmware release for field support
Sharp Remote Device Manager [SRDM] v1.4
Fusing pressure release lever setup as a service part
Fax cannot be sent to some numbers due to incorrect busy tone
detection.
Measures to reduce the vibration noise from the paper feed unit.
Registry growth when using an auto created printer under a Citrix or
terminal services environment.
Caution when disconnecting the FFC cable.
Change of gears within the main drive unit
Measures to prevent noise from the main drive unit caused by
deformed gear support plate.
Measures to prevent operating sound of fusing cooling fan in pre-heat
mode.
Enhancement of the right door on the optional 500 sheet cassette.
Improvement to reduce operating sound when feeding paper from
manual bypass tray.
Improvement for density unevenness when using document feeder.
Measures to prevent the vibration noise when the LSU cooling fan is
operating.
Improvement to prevent noise from the RSPF motor.
Improvement for noise from the RSPF
Rom version upgrade (including revision history)
Measures against L4-06 error due to the damage on 1TUD harness
Prevention of paper jam at the fuser due to lead edge adjustment
To Next Page
Loading...
Need help?
General
