Not enough free space in flash memory for resources
Contact your dealer.
Red light on the convenience stapler
Try one or more of the following:
• Close the staple access door.
• Remove the loose staples.
Note: After removing loose staples, two priming cycles are required before stapling. Insert a stack of
paper into the stapler three times. The stapling starts at the third insertion.
• Replace the staple cartridge.
Issues with supplies
Replace cartridge, printer region mismatch
Non‑Printer Manufacturer supply
The printer has detected an unrecognized supply or part installed in the printer.
Your printer is designed to function best with genuine supplies and parts made by the printer manufacturer.
Use of third-party supplies or parts may aect the performance, reliability, or life of the printer and its imaging
components.
All life indicators are designed to function with supplies and parts from the printer manufacturer and may
deliver unpredictable results if third-party supplies or parts are used. Imaging component usage beyond
the intended life may damage your printer or associated components.
Warning—Potential Damage: Use of third-party supplies or parts can aect warranty coverage.
Damage caused by the use of third-party supplies or parts may not be covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your
printer, touch and hold the error message on the display using two fingers for 15 seconds. When a
confirmation dialog box appears, touch Continue.
If you do not want to accept these risks, then remove the third-party supply or part from your printer and
install a genuine supply or part from the printer manufacturer.
If the printer does not print after clearing the error message, then reset the supply usage counter.
Troubleshoot a problem 283
To Next Page
Loading...
Need help?
General
