TROUBLESHOOTING
75
CONTENTS
Print quality is not satisfactory
(part 2)
Part of the printed image is missing
■ Did you set sufficient margins in the paper settings
of your application?
Printing is not possible at the edges of the paper. The print
margins are 5/32" (4 mm) at the top and bottom of the paper
and 1/8" (3 mm) at the sides of the paper. When configuring the
paper settings in the software application, be sure to establish
margins that are at least as large as the print margins.
■ Does the paper size set for the print image match the
size of paper loaded in the machine?
Make sure that the paper size setting matches the size of
paper loaded in the machine. When "Auto Select" is selected
for the paper source in the print settings, the print method will
vary depending on the settings of the system settings
(administrator).
☞Windows: When "Paper Selection" is set to "Auto Select"
☞Macintosh: When "Paper Feed" is set to "Auto Select"
■ Are the print orientation settings correct?
Make sure that the correct paper orientation is selected for
the print image in the application's paper settings and in the
print settings.
If the paper is loaded in the machine in a different orientation
from the print image, the image is normally automatically
rotated to match the paper; however, if this function has been
disabled in the system settings (administrator), the paper
orientation must be set in the application. (See "ROTATED
PRINT" in the "SYSTEM SETTINGS (ADMINISTRATOR)" in
the operation manual.)
To Next Page
Loading...
