Sharp SF-2540 - Key Operator Code Number: Factory Setting

99
KEY OPERATOR PROGRAMS
Key operator programs
The following is the factory setting of the Key Operator Code
Number, which must be used to access the Key Operator
Program.
Factory setting = 00000
This number must be entered when accessing the Key
Operator Program for the first time. (See page 78.)
NOTE:
The Key Operator Code Number is an important security
number allowing the Key Operator to configure the copier’s
functions and auditor’s settings.
You should register your own code number — different from
the factory setting above — immediately after your copier is
installed.
★ KEY OPERATOR
Detach this page and store it in a safe place.
✂
Key operator code number: factory setting
KEY OPERATOR CODE NUMBER:
FACTORY SETTING
Downloaded From ManualsPrinter.com Manuals