Sharp VC-H965U

34
VC-A565U/VC-H965U (26-36)
Dimensions: 257 ⳯ 182 mm
Sharp Super Picture
Recorded Section Auto Repeat
Press S. PICTURE on the VCR.
“S.PICTURE ON (or OFF)” will appear on the TV screen for a few seconds. Each time the
button is pressed, the mode switches between ON and OFF. (The Sharp Super Picture is
preset to ON at the factory.)
ON:
Normally leave the mode set to ON. This high picture quality function will create a clearer image during
playback.
OFF:
Set to OFF when playing back a tape on the VCR while editing or when strong noise appears on the screen.
• This function only operates during playback. It will not operate when recording or watching a TV programme with the VCR
tuner.
• When playing S-VHS tape
1. Sharp Super Picture is set to off automatically. When finished playback, the setting will return to the previous setting.
2. You cannot change ON/OFF setting manually.
• The ON/OFF status of the Sharp Super Picture can be checked when ON SCREEN is pressed to display OSD.
• This function cannot be set to ON/OFF with the MENU screen displayed. First close the MENU screen before operating this
function.
• When the VCR power is turned off, the Sharp Super Picture setting is retained in memory.
• If power is interrupted for more than 5 seconds (power failure, etc.), the setting will return to ON.
This function creates clearer picture quality only during playback.
S. PICTURE ON
PLAY
With this feature, if the recorded portion has finished and non-
recorded portion has continued for 15 seconds, the tape will
automatically stop, rewind to the beginning and repeat
playback.
! Press AUTO REPEAT on the remote control. The “ ” mark will appear on the screen for 3 seconds.
@ When a non-recorded portion has continued for 15 seconds after the recorded portion has finished, the
tape will stop and begin rewinding.
# The tape will rewind to the beginning and repeat playback.
$ To turn off the Recorded Section Auto Repeat function, press AUTO REPEAT once more.
• You can also set the Recorded Section Auto Repeat mode by selecting “ON” on the SET UP-selection screen. (The AUTO
REPEAT mode is preset to OFF at the factory.)
• The ON/OFF status of the Recorded Section Auto Repeat can be checked when ON SCREEN is pressed to display OSD.
(The “ ” mark lights when the Recorded Section Auto Repeat is on.)
• If the Recorded Section Auto Repeat is on and the tape is rewinded to the beginning with rewind or reverse video search,
the tape will automatically start playback.
Auto Zero Back
• During auto zero back, if the VCR rewinds (or fast forwards) the tape all the way without finding the “0:00.00” point, it will
stop at the beginning (or end) of the tape.
• The counter start point “0:00.00” may differ slightly from the starting point on the tape.
• This function is not operable during recording, recording pause, simple recording timer or timer recording.
This function automatically forwards or rewinds the cassette to the “0:00.00” point. Use this function to return to
a recording start point.
! Reset the counter to “0:00.00” with CANCEL before recording.
@ Press REC to start recording.
# After recording the desired programme, press STOP to stop recording.
$ Press ZERO BACK to return to the recording start point (0:00.00).