EasyManua.ls Logo

Sharp VIEWCAM VL-SD20S - Programme Search

Sharp VIEWCAM VL-SD20S
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VL-SD20S-GB/pp. 042-047; 99/7/28/18:00
G. K. Associates, Tokyo
Useful Features
Useful Features
Playback
43
PROG. SEARCH
FF
AUD IO 1
+
2
PROG. SEARCH
REWREW FF FF
AUD IO 1
+
2
PROG. SEARCH
EX I TREW
AUD IO 1
+
2
SP
EX I T
SP
EX I T
SP
3 Press the REW (C) (or FF [B])
button.
The tape rewinds (or fast forwards) to the
beginning of a scene immediately before
(or after) the current tape position;
playback then starts automatically.
4 To continue searching, press the REW
(or FF) button while “REW” (or “FF”) is
still displayed.
Notes:
Use this function when the tape is stopped or
during normal playback.
This function finds the beginning of each scene
immediately before or after the current tape
position. It is not possible to skip a scene.
This function cannot spot recordings that are
shorter than 10 seconds in length.
In steps 2 and 4, if the tape is at a point after the
last (or before the first) recording, the FF (or
REW) indicator will be displayed in gray and the
FF (or REW) button cannot be used.
To cancel programme search, press the EXIT
button (MODE DISPLAY).
Programme Search
The programme search function automatically
finds and plays back the beginning of a
number of previously recorded scenes. Up to
10 different scenes can be found on one tape.
Note:
This function does not work if no recording has
been made since the cassette was loaded or if
the cassette has been removed after the
recordings were made.
1 Press the CONTROL switch until
appears (VCR mode).
2 Press the SEARCH button (A).
“PROG. SEARCH” is displayed and one
of or both “REW” and “FF” will start
flashing.
Example: When using a tape with 5 different scenes.
First recording Last recording
When you are at this position:
Press the REW button (C) to rewind the tape to E and begin playback.
Press the FF button (B) to forward the tape to R and begin playback.
Video tape
Beginning of each scene
Current tape position
Monitor display
PROG. SEARCH
SP
REW
AUD I O 1
+
2
REW
EXITFF
SP
ARCHZOOM
AUD I O 1
+
2
DUB.
AUDIO
PB SE
-
PROG. SEARCH
EXITREW FF
AUD I O 1
+
2
SP
ARCH
SE
-

Table of Contents

Related product manuals