Sharp XL-MP10H - Power Connection and Remote Control Setup

04/11/1 XL-MP10H(H)E1.fm
E-6
ENGLISH
TINSZA033SJZZ
XL-MP10H
8
Preparation for Use
! AC power connection
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket.
Note:
Unplug the AC power lead from the wall socket if the unit will not be
in use for a prolonged period of time.
! To turn the power on
Press the ON/STAND-BY button to turn the power on.
Remote control
! Battery installation
Precautions for battery use:
"
Replace all old batteries with new ones at the same time.
"
Do not mix old and new batteries.
"
Remove the batteries if the unit is not to be used for long periods
of time. This will prevent potential damage due to battery leakage.
Caution:
"
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
"
Installing the batteries incorrectly may cause the unit to malfunc-
tion.
Battery removal:
Remove the battery cover. Push each battery toward the battery
terminal and take them out.
Notes concerning use:
"
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AA" size batteries (UM/
SUM-3, R6, HP-7 or similar).
"
Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
"
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
"
Keep the remote control away from moisture, heat, shock, and
vibrations.
! Test of the remote control
After use:
Press the ON/STAND-BY button to enter the power stand-by
mode.
1 Remove the battery cover.
2 Insert the supplied batteries according to the direction indi-
cated in the battery compartment.
When inserting or removing the batteries, push them toward the
battery terminals.
3 Replace the cover.
Check the remote control after
checking all the connections (see
pages 5 - 6).
Point the remote control directly at
the remote sensor on the unit.
The remote control can be used
within the range shown:
Press the ON/STAND-BY button.
Does the power turn on? Now, you
can enjoy music.
0.2 m - 6 m
Remote sensor