Sharp XL-MP10H - Cassette Tape Recording

04/11/1 XL-MP10H(H)E2.fm
E-18
ENGLISH
TINSZA033SJZZ
XL-MP10H
8
Tape Recording
Recording on a cassette tape
Before recording:
"
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
"
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
"
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
"
For recording, use only normal tapes. Do not use metal or
CrO tapes.
"
Do not use C-120 tapes or poor-quality tapes, as they may cause
malfunctions.
! Recording from a disc
Erase-prevention tab of cassette tapes:
"
When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent acciden-
tal recording or erasing.
"
To protect the recorded sound, re-
move the tab after recording. Cover
the tab hole with adhesive tape to
record on the tape without the tab.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "CD DISC" appears on
the display.
When operating with the remote control, press the CD button.
3
Load the desired disc.
4
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5
Press the button.
6
Press the button, which also
engages the button.
7
Press the button again to cancel the pause mode.
8
Press the ( ) button to start recording.
Side A
Tab for
side B
Tab for
side A