Sharp XL-MP10H - Radio Station Management

04/11/1 XL-MP10H(H)E2.fm
E-16
ENGLISH
TINSZA033SJZZ
XL-MP10H
8
Radio
Listening to the memorised station
! Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead discon-
nection.
! To recall a memorised station
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
To select a preset station with the direct number buttons:
Press the corresponding number ("0" - "+10").
Example:
To select 28, press "+10", "+10" and "8".
! To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
! To clear a memorised station
! To erase entire preset memory
1
Perform steps 1 - 3 in "Listening to the radio" on page 15.
2
Press the MEMORY/SET (MEMO-
RY) button to enter the preset tun-
ing saving mode.
3
Within 5 seconds, press the PRE-
SET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 5 seconds, press the MEM-
ORY/SET (MEMORY) button to
store that station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired sta-
tion is located.
1 Recall the memorised station.
2 Whilst it is displayed, press the
MEMORY/SET (MEMORY) button.
3 Within 5 seconds, press the CLEAR
button on the remote control.
1 Press the ON/STAND-BY button to enter the power stand-by
mode.
2 Whilst pressing down the MEMORY/SET button and the PRE-
SET button, press the ON/STAND-BY button until "TUCL" ap-
pears.