12 - POWER STEERING
215
5. Position the spool and sleeve so that their ends are
flush and insert the pin, 1, through the assembly
until its ends are below the surfaces of the sleeve.
6. Orient the spool and sleeve, 1, so that the pin is
horizontal to the bench and carefully insert the
assembly into the bottom of the steering valve
housing, Rotate the assembly slightly while
inserting it to ease installation. Position the spool
and sleeve so that their ends are flush with the
bottom of the steering valve housing and make
sure that the assembly turns freely within the
housing.
7. Insert a thrust bearing race, 1, the thrust bearing, 2,
then the other thrust bearing race, 1, into place
making sure it seats firmly on the sleeve and spool.
8. Install a new quad seal, 1, O-ring, 3, and dust seal,
2, in the gland bushing. Next, insert the bushing
into the housing while slightly rotating it.
30
31
32
33
To Next Page
