Shimadzu LC-10/20 System 4 Using the control module
MTP Sample Order
Defines the numbering of wells in the plate when the MTP Tray is used. If
other trays are used, this option is ignored. Possible parameters are
Horizontal or Vertical.
Rack Changer Installed
Enables the rack changer control in case a rack changer is installed.
Rinse Pump Installed
Enables the control of the rinse pump (if it is installed).
Supports Pretreatment
Enables the display of the Pretreatment sub-tab of the Method Setup - AS
dialog. For this option to function, it is necessary to have the Pretreatment
option installed in the hardware.
- 46 -
To Next Page
Loading...
