55
Drive unit setting data backup function (SC-E8000/SC-E6010)
The data saved to the drive unit is usually backed up automatically. However, performing the following operations will cause
a message to appear asking whether or not to update the backup data.
•
Reinstalling the cycle computer on a bicycle with different settings.
•
Changing the drive unit settings via E-TUBE PROJECT.
Connection and communication with devices
The system can be configured and firmware can be updated when the bicycle is connected to a device.
You need E-TUBE PROJECT to configure SHIMANO STEPS and update firmware.
Download E-TUBE PROJECT from the support website (http://e-tubeproject.shimano.com).
For information on how to install E-TUBE PROJECT, check the support website.
NOTICE
Connecting to devices is not possible while charging.
• SM-PCE1/SM-PCE02 is needed to connect SHIMANO STEPS to a PC. SMJC40/SM-JC41 will be needed in the following situations.
-
There are no free E-TUBE ports on the cycle computer (for example, if using electronic gear shifting)
-
If connecting the switch unit by itself to the PC
• Firmware is subject to change without notice.
If necessary, contact the place of purchase.
To Next Page
Loading...
