Shimano BeastMaster 9000 - Step 1: Lower Rig and Press 0 Set; Step 2: Alarm and Completion

38
Let’s Try Zero Setting
21
Hold
Peep-Peep
Do NOT wind too much line onto the spool as
this can cause inaccurate readings when setting
zero in one of the Learning Modes.
Caution
* It may not be possible to zero the counter if Jigging Mode is ON.
Always turn Jigging Mode OFF before zeroing the counter.
Lower the rig to the surface and press 0 Set
for more than 3 seconds.
The alarm will sound (peep-peep) and the
display will change as shown above.
Zero setting is complete.