索 引
一 安全上的注意事項
1-1 作業環境的安全
1-2 安裝的安全
1-3 操作中的安全
1-4 保養維修的安全
1-5 危險標示﹒請注意標示
二 使用說明
A 安裝
B 潤滑
C 潤滑油之更換
D 濾油器之更換
E 針之更換
F 穿線方式
G 押腳壓力強度之調整
三 調整說明
A 針棒高度之調整
B 針與勾針之時位關係
C 下勾針與針之引量
D 勾針與針之間隙關係
E 針與後護針片調整
F 針與前護針片調整
G 針與上勾針及線導片之關係
H 送步齒高度調整
I 勾針控線凸輪之調整
四 自動切線調整說明
A 下切刀組相關位置調整
B 下切刀組切線之相關位置
C 下切刀組與針線及下勾針線之關係
D 上切刀組與上飾線﹒針及上勾針之關係
E 撥線器相關位置調整
五 簡易故障排除
A 清潔保養
B 故障（用戶）自主檢查
C 結論
INDEX
頁/PAGE
SAFETY PRECAUTION
1-1 WORK ENVIRONMENT 1
1-2 SAFETY IN INSTALLATION 2
1-3 SAFETY IN OPERATING 3
1-4 SAFETY IN MAINTENANCE AND REPAIRS 3
1-5 DANGER ANDCAUTION SIGNS 4
OPERATION GUIDE
A INSTALLATION 5
B LUBRICATION OIL 6
C OIL CHANGE 7
D REPLACING OIL FILTER 7
E HOW TO REPLACE THE NEEDLES 8
F THREADING 8
G ADJUSTING THE PRESSURE OF PRESSER FOOT 9
ADJUSTMENT GUIDE
A THE HEIGHT OF NEEDLE BAR 10
B TIMING OF NEEDLE AND LOOPER 11
C THE POSITION OF NEEDLE AND LOOPER 12
D THE TIMING OF NEEDLE AND LOOPER 13
E
ADJUSTING NEEDLE AND REAR NEEDLE GUARD
14
F
ADJUSTING NEEDLE AND FRONT NEEDLE GUARD
15
G
"THE RELATIVE POSITION OF NEEDLE,SPREADER"AND SPREADER THREAD GUIDE
16
H ADJUSTING THE HEIGHT OF FEED DOG 17
I THE ADJUSTMENT OF LOOPER THREAD TAKE-UP 17
AUTO THREAD TRIMMER ADJUSTMENT GUIDE
A
THE RELATIVE POSITION ADJUSTMENT OF BOTTOM TRIMMER CUTTING PARTS TRIMMER CUTTING PARTS
18
B THE RELATIVE POSITION ADJUSTMENT OF BOTTOM TRIMMER﹒ 20
C
"THE RELATIVE POSITION OF NEEDLE, LOOPER" THREAD AND BOTTOM TRIMMER﹒
22
D
"THE RELATIVE POSITION OF SPREADER THREAD," "NEEDLE, SPREADER AND TOP TRIMMER﹒"
23
E THE RELATIVE POSITION OF TOP WIPER 25
REGULAR MAINTENANCE
A THE CLEAR AND MAINTENANCE 26
B
ERROR MESSAGES(THE USER INSPECTS THE MACHINE BY THEMSELVES)
28
C CONCLUSION 32
To Next Page
Need help?
General
