Shining 3D Transcan-C - Software Setup and Updates; Software Installation and Updates

Shining 3D Transcan-C_User Manual_V1.4.2
8
2. Set Software
2.1. Download the Software
Step 1: Go to https://www.einscan.com/support/download/.
Step 2: Select your scanner model.
Step 3: Download the software to your operating computer.
Note:
You are required to register before downloading.
2.2. Install the Software
1. Double click installation package, accept the modification on your computer.
2. Follow the instructions to complete the software installation.
3. After the software is installed, a shortcut will be created on your desktop. Double-click to
open the software.
2.3. Firmware Update
When the scanner firmware is incompatible, a message will appear when software is open.
Click Upgrade and follow the instruction to update the device firmware.
 Firmware updating will take around 3 mins.
 Power off the device after upgrading successfully.
 Reconnect the device, and open the software again, the device is running under the
latest firmware.
Note before installation: Administrator rights are required for the installation of the software.