Shure Incorporated
19/38
•
Resetting the Transmitter
Restores the transmitter to the following factory settings:
Controls = unlocked
Press and hold the transmitter link button while turning on the transmitter until power LED turns off.
When the link button is released, the transmitter will automatically initiate linking to find an available receiver. Press the link but
ton on an available receiver to relink.
Troubleshooting
Issue Indicator Status Solution
No sound or faint sound
Receiver RF LED on
Verify all sound system connections or ad
just gain as needed.
Verify that the receiver is connected to mix
er/amplifier.
Receiver RF LED off
Turn on transmitter.
Make sure the batteries are installed correct
ly.
Link transmitter and receiver.
Charge or change transmitter battery.
Receiver display off
Make sure AC adapter is securely plugged
into electrical outlet.
Make sure receiver is powered on.
Transmitter indicator
LED flashing red
Charge or change transmitter battery.
Transmitter plugged
into charger.
Disconnect transmitter from charger.
Audio artifacts or dropouts RF LED flickering or off
Change receiver and transmitter to a differ
ent group and/or channel.
Identify nearby sources of interference (cell
phones, WiFi access points, signal proces
sor, etc.) and shutdown or remove source.
Charge or change transmitter battery.
Ensure that receiver and transmitter are po
sitioned within system parameters.
System must be set up within recommended
range and receiver kept away from metallic
surfaces.
To Next Page
Loading...
