Sicam SBM 95 - Special Programming; Display and Feedback Settings; Gauge and Operation Settings; Measurement and Zeroing

COD.642400 Rev. 1
18
SPECIAL
PROGRAMMING
1G OR 5G INTERVAL DISPLAY
The weight display can be in intervals of fives or in ones. If the display is already in fives,
press "C 2 1 E" to change to ones. If the display is already in ones, press "C 2 1 E" to change
to fives.
To memorize the interval setting, press "STOP CAL 5 2 6 E".
ENABLING AND DISABLING GAUGE SETTINGS
If the machine has already been calibrated, there is the possibility to enable or disable the
automatic gauge function. If the automatic gauge is active, it is de-activated by pressing "C 2
3 5 E" , and reactivated in the same way. To store the selection press "STOP CAL 5 2 6 E".
SILENT FUNCTION
To de-activate the "Beep" that sounds when keys are pressed and at other times, press "C 1 6
E". It is re-activated in the same way.
To store the selection press "STOP CAL 5 2 6 E".
HOW TO ENTER MEASUREMENTS IN mm
No special operations are required for this. Simply enter the readings in mm as they appear
on the wheel.
SWITCH ON BY LOWERING THE GUARD
To start the machine simply by lowering the guard, press buttons "C 1 5 E". To change back
to operation only via the control panel, repeat the operation.
To store the selection press "STOP CAL 5 2 6 E"
WEIGHT DISPLAY IN GRAMS OR OUNCES
To change the display from grams to ounces , press "C 2 0 E". To change the display from
ounces to grams, press "C 1 8 E". To store the selection press "STOP CAL 5 2 6 E".
ZEROING SMALL WEIGHTS IN GRAMS
To zero small weights in grams (2 - 3 g) press "C 7 E". The present zeroing figure setting is
displayed to the left of the display. To change the figure, simply enter the new one (max. 1
figure after the decimal point), and press button "E" to confirm the figure. To store the setting
press "STOP CAL 5 2 6 E".
PROGRAMMING FOR BALANCING MOTORCYCLE
WHEELS
STATIC
• Set the width and diameter figures on the front panel (even if the wheel balancer has automatic
gauges - with static, balancing measurements must be set manually).
• The rim width measurement is made using the gauge supplied with the machine.
• The rim diameter measurement is taken from the tire.
• After running the measuring cycle, fit a weigth as indicated on the central part of the rim width.
DINAMIC
• For the dynamic balancing of motorcycle wheels follow the programming instructions for normal
wheel balancing.