COD.642400 Rev. 1
20
ROUTINE MAINTENANCE
machine cleaning and maintenance by the user
To guarantee the efficiency and correct functioning of the machine it is essential to clean it and
to conduct periodic routine maintenance. The operations of routine maintenance must be
carried out by the user according to the maker's instructions given below:
Before proceeding to any cleaning or maintenance operations remove the plug from
the electrical socket.
MECHANICAL PARTS: The cone adaptor device and the fixing devices must be kept clean,
and lightly lubricated with non corrosive oil even when not in use. The accuracy of balancing
depends to a large extent upon their condition.
TRANSPORT AND MOVEMENT
fig,23a
fig.23b
Whenever it is necessary to move or transport the machine take all the necessary
precautions! For the methods of harnessing and lifting the machine, refer to the instructions
in figs. 23a (SBM95 ) and 23b ( SBM 99S).
STORAGE AND SCRAPPING
PERIODS OF INACTIVITY PERMANENT STORAGE SCRAPPING
Whenever it is decided
to temporarily store the
machine, and during
periods in which the
machine is not in use,
remove the plug from
the electrical supply.
If it is decided that this
machine is no longer to be
used, it is advisable to
make it inoperative by
removing the electrical
cable after having
disconnected the plug
from the supply.
Since the tyre changing
machine is considered
as special refuse, it
should be dismantled
into homogeneous
parts and disposed of
according to the laws in
force.
To Next Page
Loading...
