EasyManua.ls Logo

SICK deTec4 Core Ex - 12 Technical Data; Data Sheet; General System Data; Technical Data for Sender

SICK deTec4 Core Ex
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 Technical data
12.1 Data sheet
Table 8: General system data
Minimum Typical Maximum
Protective field height, depending on
t
ype
600, 900, 1,200, and 1,500 mm
Resolution (detection capability) 30 mm
Scanning range
1)
2)
3)
Resolution 30 mm 8 m 10 m
Minimum distance between sender and receiver
Resolution 30 mm 0 m
Protection class
4)
III (IEC 61140)
Enclosure rating IP 66
5)
(IE
C 60529)
Supply voltage U
V
a
t the device
6)
7)
19.2 V 24 V 28.8 V
Residual ripple
8)
± 10%
Synchronization Optical
Type Type 4 (IEC 61496-1)
Category Category 4 (ISO 13849-1)
Performance level
9)
PL e (ISO 13849-1)
Safety integrity level
9)
SIL3 (IEC 61508)
SIL claim limit
9)
SILCL3 (IEC 62061)
PFHd (mean probability of a danger‐
ous f
ailure per hour)
3.7 × 10
-9
T
M
(mission time) 20 years (ISO 13849-1)
Safe state when a fault occurs At least one OSSD is in the OFF state.
Power-up delay of sender and
r
eceiver after supply voltage is
applied
2 s
1)
If the protective fields are very wide, there is a possibility that all four alignment quality LEDs will not light
up e
ven when alignment is good.
2)
The minimum scanning range specifies a range in which a function is guaranteed to operate correctly and
safely under industrial conditions. A sufficient level of signal reserve to ensure very high availability is
included in the calculation.
3)
The typical scanning range specifies a range in which the safety light curtain operates correctly and
safely under industrial conditions. The level of signal reserve is enough to ensure high availability.
4)
SELV/PELV safety/protective extra-low voltage.
5)
In order to achieve enclosure rating IP 66, washers must be used for the fixing screws on the enclosure
cover.
6)
The external voltage supply must jumper a brief power failure of 20 ms as specified in IEC 60204-1. Suit‐
able power supply units are available as accessories from SICK.
7)
A fuse rated maximum 2 A shall be installed in the isolated 24 V DC power supply circuit to the device in
order to limit the available current.
8)
Within the limits of U
V
.
9)
For more detailed information on the exact configuration of your machine, please consult your respective
SIC
K subsidiary.
Table 9: Technical data for sender
Minimum Typical Maximum
Wavelength of sender Near-infrared
(NIR
), invisible
12 TECHNICAL DATA
60
O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Ex 8017023/14Q6/2020-04-27 | SICK
Subject to change without notice

Table of Contents

Related product manuals