SICK deTec4 Core Ex - Unpacking; Mount the Safety Light Curtain in the Explosion-Proof Enclosure (Only if the Safety Light Curtain Is Used in North America)

DANGER
H
azard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
b
Do not do repair work on device components.
b
Do not make changes to or manipulate device components.
b
Apart from the procedures described in this document, the device components
must not be opened.
CAUTION
Ris
k of injury due to heavy weight
Lifting and moving heavy loads may cause injury.
Unsecured heavy loads may, for example, fall over and cause bruising.
b
Only lift the device using equipment or two persons.
b
Wear suitable protective clothing and safety shoes.
NOTE
Mount t
he device in the following order.
Prerequisites
T
he construction of the safety light curtain has been correctly executed.
Further topics
•
"Design", page 16
•
"Technical data", page 60
5.2 Unpacking
Approach
1.
Check the components for completeness and the integrity of all parts.
2. Please contact your respective SICK subsidiary should you have any complaints.
Further topics
•
"Ordering information", page 68
5.3 Mount the safety light curtain in the explosion-proof enclosure (only if the safety
li
ght curtain is used in North America)
Important information
NOTE
If t
he device in pre-mounted condition has been purchased, please skip this section.
DANGER
Ris
k of ignition or explosion
b
Use fixing screws with a yield point of at least 640 MPa to attach the cover to the
explosion-proof enclosure.
5 MOUNTING
32
O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Ex 8017023/14Q6/2020-04-27 | SICK
Subject to change without notice