17 List of tables
1. Target groups and selected chapters of these operating instructions......................6
2. Formula for calculating the minimum distance to reflective surfaces with auto‐
ma
tic calibration of the protective field width.......................................................... 21
3. Minimum wire cross-section for protection earth (PE).............................................44
4. System connection pin assignment (flying leads, 5-wire)........................................45
5. Indication of the alignment quality............................................................................50
6. Fault indicator on the sender.....................................................................................57
7. Fault indicator on the receiver................................................................................... 57
8. General system data.................................................................................................. 60
9. Technical data for sender...........................................................................................60
10. Technical specifications, receiver.............................................................................. 61
11. Operating data............................................................................................................ 61
12. Response time dependent on the protective field height........................................62
13. Power consumption, sender and receiver.................................................................62
14. Maximum lengths of cable for wire cross-section 0.34 mm
2
, copper wire............ 62
15. Weight of sender and receiver...................................................................................63
16. Ordering information deTec4 Core Ex, resolution 30 mm........................................68
17. Brackets ordering information................................................................................... 69
18. Mounting accessories ordering information............................................................. 70
19. Cable gland ordering information.............................................................................. 70
20. Ordering information for power supply......................................................................70
21. Alignment aid ordering information...........................................................................70
22. Scanning range with and without 1 or 2 deflector mirrors...................................... 72
23. Ordering information for PNS75 deflector mirror..................................................... 72
24. Ordering information, deflector mirror PSN125....................................................... 72
25. Ordering information, test rods..................................................................................72
26. Note on specified standards......................................................................................74
LIST OF TABLES 17
8017023/14Q6/2020-04-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Ex
77
Subject to change without notice
To Next Page
Loading...
