What to do if SICK C4-RD receiver recognizes beams from several senders?
If the SICK Lighting Equipment receiver recognizes beams from several senders, first check the distance to senders of the same type. Then, ensure that beams from another sender cannot reach the receiver.
What to do if SICK Lighting Equipment sender identified an internal fault?
If your SICK Lighting Equipment sender identifies an internal fault, try switching the voltage supply off and then on again. If the fault continues, consider replacing the sender.
How to fix a permanent error in the voltage supply of SICK C4-RD Lighting Equipment?
If the SICK Lighting Equipment has a permanent error in the voltage supply, replace the device.
How to troubleshoot low operating voltage in SICK C4-RD?
If the operating voltage of your SICK Lighting Equipment is too low, or there's an internal fault, check the voltage supply. Switch the voltage supply off and then on again. If the fault persists, replace the sender.
What to do if the voltage was too high when operating the SICK Lighting Equipment sender?
If the voltage was too high when operating the SICK Lighting Equipment sender, check the voltage supply. Replace the sender if necessary.
What to do if fault identified on the OSSDs of the SICK Lighting Equipment?
General| Brand | SICK |
|---|---|
| Model | C4-RD |
| Category | Lighting Equipment |
| Language | English |
Provides critical safety warnings and guidelines for integrating the safety component.
Details the intended applications and limitations of the C4-RD safety light curtain.
Lists unsuitable applications and scenarios where the device should not be used.
Specifies the necessary qualifications for personnel involved in installation and operation.
Describes the components, working principle, and optical setup of the safety light curtain.
Details responsibilities and safety requirements for the machine manufacturer.
Outlines operator responsibilities and safety considerations for integrating the device.
Provides guidance on connecting the safety light curtain to machine control systems.
Defines procedures for checking the safety function during commissioning and regular intervals.
Details the physical installation steps and positioning requirements for the device.
Details the process of aligning the sender and receiver for optimal performance.
Emphasizes safety procedures to follow when troubleshooting issues with the device.
Presents detailed technical specifications and parameters for the safety light curtain system.
A checklist to verify compliance and functionality during setup and recurring tests.
To Next Page
